Darwin Service

Electronics Repair & Design Darwin

Circuit board repair, inverter repair, PCB diagnostics, and electronics support for commercial, industrial, and field systems with a repair-first, longevity-focused approach.

We work on PCBs, circuit boards, inverters, power supplies, embedded controllers, interfaces, and legacy electronic assemblies from our Winnellie workshop.

Scope can extend from fault isolation and service through redesign, reverse engineering, replacement boards, test fixtures, and prototype support. Where redesign is needed, the aim is maintainability, upgradeability, and longer service life rather than a short-term patch.

Book a free consultation Call 0410 152 013 Engineering & R&D

Service scope

Boards, controllers, redesign, and validation support.

Diagnostics & Circuit Board Repair

Circuit board repair — component-level fault finding and soldering
PCB diagnostics, trace repair, and pad rework
Controller and interface board service
Power path and signal integrity fault isolation

Inverter, Power Supply & Embedded Repair

Inverter repair — solar inverters, power inverters, and UPS units
Power supply repair and rebuild — switch-mode, linear, and DC-DC converters
Firmware-assisted diagnostics and embedded system fault tracing
Stability fixes, upgrade paths, and reliability improvements

Redesign & Replacement Boards

PCB design and redesign for failed or legacy boards
Prototype builds, replacement assemblies, and validation planning
Reverse engineering where documentation is missing, with future serviceability designed in where practical

Test & Support Tooling

Custom fixtures and test equipment for fault reproduction
Workshop fabrication support for brackets, enclosures, and mounts
Documentation, handover notes, and support records where ongoing maintenance is required

Location

Workshop-based support across Darwin and the surrounding NT.

Based in Winnellie, we provide electronics diagnostics, controller service, redesign, and related workshop support for Darwin metro and surrounding Northern Territory jobs.

Service areas (approx. 30km from Darwin CBD) include Darwin City, Larrakeyah, The Gardens, Stuart Park, Woolner, Parap, Winnellie, Bayview, Fannie Bay, Ludmilla, The Narrows, Rapid Creek, Coconut Grove, Nightcliff, Jingili, Millner, Moil, Tiwi, Nakara, Casuarina, Alawa, Brinkin, Anula, Malak, Marrara, Berrimah, Leanyer, Wanguri, Wulagi, Karama, Sanderson, Lyons, Muirhead, Lee Point, Buffalo Creek, East Arm, Palmerston City, Bakewell, Gray, Gunn, Driver, Durack, Moulden, Rosebery, Bellamack, Johnston, Zuccoli, Farrar, Marlow Lagoon, Woodroffe, Archer, Mitchell, Yarrawonga, Holtze, Howard Springs, and Virginia.

For broader IT work, see IT & Communications. For advanced builds, see Engineering & R&D.

Contact

Address
4/143 Coonawarra Rd
Winnellie NT 0820

Phone
0410 152 013

Email
inquiries@iatrt.com

Consultations

Free consultation by phone or at our Winnellie workshop. On-site callouts are charged separately. The initial consultation is used to confirm scope, expected effort, and the most appropriate next step before major work begins.

We provide clear scope, timing, and cost expectations before major work starts.